HP Nc4010 HP Compaq nc4010 Notebook PC - Maintenance and Service Guide - Page 137
Two T8M2.0×6.0 screws, in front of the hard drive bay
View all HP Nc4010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Removal and Replacement Procedures 2. Position the base enclosure so the rear panel is facing toward you. 3. Remove the following screws: ❏ Two T8M2.0×6.0 screws 1 from the rear panel ❏ One T8M2.0×4.0 screw 2 in the upper right corner of the system board ❏ One T8M2.0×4.0 screw 3 in front of the hard drive bay ❏ One T8M2.0×4.0 screw 4 in the lower left corner of the system board 4. Use a 5.0-mm socket to remove the two M2.0×9.0 standoffs 5 that secure the system board to the base enclosure. Removing the System Board Screws 5-58 Maintenance and Service Guide
5–58
Maintenance and Service Guide
Removal and Replacement Procedures
2. Position the base enclosure so the rear panel is facing
toward you.
3. Remove the following screws:
❏
Two T8M2.0×6.0 screws
1
from the rear panel
❏
One T8M2.0×4.0 screw
2
in the upper right corner of
the system board
❏
One T8M2.0×4.0 screw
3
in front of the hard drive bay
❏
One T8M2.0×4.0 screw
4
in the lower left corner of
the system board
4. Use a 5.0-mm socket to remove the two M2.0×9.0
standoffs
5
that secure the system board to the base
enclosure.
Removing the System Board Screws