HP NetServer LXr Pro8 HP Netserver LPr NetRAID-4M Config Guide for Windows 20 - Page 3

SCSI ID Channels RAID levels Containers Configuration options: Cabinet Disk drives: No. of cabinets Model Status SCSI ID Disk SCSI Ids Cables LANs LAN connection NIC: Model Driver No. of NICs 6, 7 0, 1, 2, 3 All fault tolerant RAID types supported by controller: 1, 5, 10 (Stripe set of mirror sets RAID 0/1), 50 (Stripe set of RAID-5 sets), Volume set of mirror sets, Volume set of RAID-5 sets Single-level or multi-level Must be fault-tolerant 8 maximum per cluster Write Cache Disabled Clustering Enabled Domain Validation Enabled Any HP drive supported by storage enclosure. Any combination of HP disk models is allowed in a diskset, on a SCSI channel, or in a cluster. 1 - 8 Rack Storage/12 D5989B or C plus two D6205B or two D6025C SCSI controllers for each Rack Storage/12 5 (fixed) 0 - 3, 8 - 15 (fixed) Any 2 HP LVD SCSI offset cables per RS/12 from the following list: 1 meter D7131A 2.5 meter D6020A 5 meter D6982A 10 meter D6983A Intra-cluster (Heartbeat) LAN HP D5954A crossover cable or equivalent. The intra-cluster LAN may only be used for cluster node communication. It may not be used for client communication. Client LAN Any LAN Embedded NIC Hptxnt5.sys 4.02.27 (Navigator L.20.00) or later 1 Any that is on both the HP Tested Products List and the Microsoft® Hardware Compatibility List. Vendor supported driver NOTE If the NIC used is the same as the Intra-cluster LAN (HP D5013B), then the Client LAN must use the same driver as the Intra-cluster LAN. 1 minimum 3