HP P6000 HP StorageWorks Small Form Factor Disk Enclosure Backplane replacemen - Page 2
Removing the backplane, Disengage both I/O modules.
View all HP P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Removing the backplane 1. Schedule a maintenance window. 2. Stop all I/O to the enclosure. 3. Power down the enclosure by pressing and holding the On/Standby button on the rear of disk enclosure, until the system power LED changes from green to amber. 4. Remove all cabling from the rear of the enclosure. Ensure all cabling is marked to facilitate re-cabling later. 5. Label the disk drives with the drive bay identification labels (5697-0279) included in the replacement kit. 8. Remove the top access panel. a. Lift the access panel latch (1). The access panel will slightly disengage from the enclosure. b. Slide the access panel to the rear (2) and lift away from the chassis. CAUTION: Reinstalling a disk drive in a drive bay other than the one from which it was removed may cause data loss. Apply the appropriate drive bay identification label to the handle of each disk drive. Table 1 Small form factor disk enclosure drive bay layout 1 6 11 16 21 2 7 12 17 22 3 8 13 18 23 4 9 14 19 24 5 10 15 20 25 6. Remove all disk drives from the enclosure. Press the release button on the lever (1) and rotate the lever to the left (2). Then, pull the disk drive out of the drive bay (3). NOTE: A Torx tool is provided inside the enclosure chassis, on top of the I/O module housing. 9. Disengage both I/O modules. a. Squeeze the button on the bottom of the locking lever (1) and rotate out the handle (2). b. Position one hand under the module, and with the other hand, pull the module out of the enclosure (3). 10. Disconnect all cables from the backplane. 7. Loosen the thumbscrews that secure the enclosure to the front of the rack, and remove the enclosure from the rack. Page 2