HP Pavilion zd7000 Expansion Base - Maintenance and Service Guide - Page 40
power connector, from the supports in the base enclosure.
![]() |
View all HP Pavilion zd7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Removal and Replacement Procedures 6. Turn the base enclosure right-side up with the rear facing you. 7. On the base enclosure, disconnect the power supply cable 1 from the system board. 8. Lift the power supply and shield approximately one inch 2. 9. While holding the power supply and shield, remove the power connector 3 from the supports in the base enclosure. Removing the power supply Reverse the above procedure to install the power supply. Maintenance and Service Guide 5-11
![](/manual_guide/products/hewlettpackard-zd7005qv-expansion-base-maintenance-service-guide-710b247/40.png)
Removal and Replacement Procedures
Maintenance and Service Guide
5–11
6. Turn the base enclosure right-side up with the rear
facing you.
7. On the base enclosure, disconnect the power supply cable
1
from the system board.
8. Lift the power supply and shield approximately one inch
2
.
9. While holding the power supply and shield, remove the
power connector
3
from the supports in the base enclosure.
Removing the power supply
Reverse the above procedure to install the power supply.