HP Pavilion zt1100 HP Pavilion Notebook zt1000, xz100 and Omnibook xt1000 Seri - Page 16
CD and DVD Problems - notebook pc series
View all HP Pavilion zt1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
CD and DVD Problems If you can't boot from a CD in the CD/DVD drive • Make sure the CD is bootable, such as a Recovery CD. • Make sure the CD-ROM/DVD drive is selected as the boot device-see "Changing the Boot Device" on page 11. • Restart the notebook. • Test the CD/DVD drive with the e-Diagtools diagnostics- see "Using the e-Diagtools Diagnostic Tests" on page 32. If a CD or DVD plays erratically • Dirt or smudges can cause a disk to skip. Clean the disk with a soft cloth. If the disk is badly scratched, it may have to be replaced. • Some DVDs include software called "PC Friendly." You generally should not install this software, as it can cause errors or erratic play. If needed, uninstall it and restart the notebook. If a DVD movie stops playing in the middle • You may have accidentally paused the DVD movie. Press the Play button to resume. • The DVD may be double-sided. Open the DVD tray, and read the text near the center of the disk. If it says Side A, flip the disk over, close the tray, and press the Play button to continue playing the movie. If you get a Region Code error when playing a DVD movie • DVDs have regional codes embedded in their disk data. These codes prevent DVD movies from being played outside the region of the world in which they are sold. If you get a Region Code error, you are trying to play a DVD intended for a different region. Important: Most DVD drives let you change the region code only a limited number of times (usually no more than four) to allow you to set the proper region code for your area. Please note that when you reach this limit, your last change to the region code will be hard-coded on the DVD drive, and will be permanent. The HP warranty does not cover the expense of correcting this situation. Refer to the help for the DVD player software for details about setting region codes. If the notebook cannot read a CD or DVD • For a single-sided CD or DVD, make sure the disk is placed in the drive with the label facing up. • Clean the disk with a soft cloth. • Wait 5 to 10 seconds after closing the tray for the notebook to recognize the disk. • Remove the disk from the drive, then restart the notebook. • If you created the CD on a CD-RW drive, try using a different media brand. For best results use HP certified media. While other media may work, HP cannot guarantee compatibility. 16 Troubleshooting and Diagnostics zt1100/xz100 and xt1000 Series Troubleshooting and Self-Repair Guide