HP Point of Sale rp5000 Getting Started (3rd Edition) - Page 31

depends on your, voltage setting

Get HP Point of Sale rp5000 PDF manuals and user guides View all HP Point of Sale rp5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Getting Started Diagnostic Front Panel LEDs and Audible Codes Activity System does not power on and LEDs are not flashing. Beeps None Possible Cause System unable to power on. Recommended Action Press and hold the power button for less than 4 seconds. If the hard drive LED turns green, then: 1. Check that the voltage selector, located on the rear of the power supply, is set to the appropriate voltage. Proper voltage setting depends on your region. 2. Remove the expansion cards one at a time until the AUX LED on the system board turns on. 3. Replace the system board. Getting Started www.hp.com 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Getting Started
Getting Started
www.hp.com
27
System does not
power on and
LEDs are not
flashing.
None
System unable to
power on.
Press and hold the
power button for less
than 4 seconds. If the
hard drive LED turns
green, then:
1. Check that the
voltage selector,
located on the rear
of the power supply,
is set to the
appropriate
voltage. Proper
voltage setting
depends on your
region.
2. Remove the
expansion cards
one at a time until
the AUX LED on the
system board turns
on.
3. Replace the system
board.
Diagnostic Front Panel LEDs and Audible Codes
Activity
Beeps
Possible
Cause
Recommended
Action