HP ProLiant DL360e HP Smart Update Manager 5.1 Release Notes - Page 7

Be sure that the following platform-specific compatibility libraries are also installed. • For Red Hat Enterprise Linux 5 x86 servers: ◦ libnl (required for QLogic and Emulex drivers and firmware) • For Red Hat Enterprise Linux 5 AMD64/EM64T servers: ◦ libnl (required for QLogic and Emulex drivers and firmware) • For SUSE Linux Enterprise Server 10 x86 servers: ◦ libnl (required for QLogic and Emulex drivers and firmware) • For SUSE Linux Enterprise Server 10 AMD64/EM64T servers: ◦ libnl (required for QLogic and Emulex drivers and firmware) ◦ e2fsprogs-32bit NOTE: This library is graphical only, however, it is required to use HP SUM in Console mode. ◦ fontconfig-32bit • For SLES 11 x86 servers: ◦ libstdc++33-3.3.3-11.9.i586 or later ◦ libnl (required for QLogic and Emulex drivers and firmware) • For SLES 11 AMD64/EM64T servers: ◦ libstdc++33-32bit-3.3.3-11.9 or later ◦ libnl (required for QLogic and Emulex drivers and firmware) Enable the network ports that HP SUM uses. For more information, see the Enabling ports section in the HP Smart Update User Guide. Minimum requirements for Red Hat Enterprise Linux 6 servers • Ensure that each NIC has an IP address assigned. To get the IP address assigned to a NIC, enter the dhclient command in the console, which launches the NIC interfaces and retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start up. • RHEL6 console mode NOTE: No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must install the base server with defaults and the following RPMs. ◦ Load the hp-snmp-agents rpm and rpms based on hp snmp agent: - lm_sensors-libs-3.1.1-10.el6..rpm - net-snmp-libs-5.5-27.el6..rpm - net-snmp-5.5.27.el6..rpm ◦ To build Linux drivers from source: - kernel-headers-2.6.32-71.el6..rpm - redhat-rpm-config-9.0.3-25.el6.noarch.rpm - kernel-devel-2.6.32-71.el6..rpm Prerequisites 7