HP Rp2430 rp24xx A180 User Manual - Page 72
Second Level Cache Memory HPMC Fault., Firmware Warning Messages, Description/Action Required
View all HP Rp2430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
A-Class System Service A-Class Server Trouble Shooting Second Level Cache Memory HPMC Fault. SLC faults occur when an HPMC, in response to a SLC failure, prevents the system from completing selftest. Chassis codes provided by the HSC Remote Management card are useful in troubleshooting this type of error. If power cycling the server clears the fault, continue troubleshooting by using the "ser pim" command at the firmware main menu screen. Check the timestamp on the PIM data to see if the time recorded corresponds to the time of the failure. For assistance with decoding an HPMC, contact Hewlett-Packard. Firmware Warning Messages Firmware is the name given to the system boot instructions and selftest software that is imbedded into a computer chip instead of stored on disk. Firmware also includes warnings and error messages that are displayed on the console when selftest finds an error. Those warnings and messages, and a brief description or action requirement of each, is shown in the table included below: Firmware Warning Messages Description/Action Required WARNING: Stop boot flag set. System cannot boot. This message accompanies those warnings that prevent the system from booting. Look up the accompanying message and take appropriate action. WARNING: Not enough memory to boot the OS. Ensure that the minimum amount of memory is installed WARNING: Setting DEFAULTS has failed. The MFIOC chip failed. This failure requires replacing the EBU. WARNING: Memory has been initialized but not tested as a result of FASTBOOT being enabled. To test memory, use the 'FASTBOOT' command in the CONFIGURATION menu and reboot the system. Disable FASTBOOT by the 'Fastboot OFF' command in the CONFIGURATION menu and reboot. WARNING: The processor has failed selftest due to a co-processor failure. WARNING: The processor has failed selftest. WARNING: One or more memory banks were not configured due to a SIMM size mismatch or a SIMM failure. For more details, use the MEMORY command in the INFORMATION menu. This condition requires replacing the EBU. A processor selftest failure requires replacing the EBU. Use the MEMORY command in the INFORMATION menu to determine correct configuration. WARNING: The Bus Converter has failed. A Bus Converter failure requires replacing the EBU. 72 Chapter 3