HP Scitex FB10000 Geffen TS Error 66115 - Page 3

If the SSR LED is ON, then either the small heater is faulty or one of its wires disconnected.

Get HP Scitex FB10000 PDF manuals and user guides View all HP Scitex FB10000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Error ID: 66115: Unified Cooler - Small heater SSR fault FB10000 Error Messages Troubleshooting 7. Ask a colleague to monitor the Small Heater SSR LED [SSR_H1] while you perform the following tests: When cooler is idle, the SSR should be OFF, when cooler is running this Led should be lit. SSR_H1 in Unified cooler electric panel 8. Start the Cooler from the Service Tool application window. 9. If the SSR LED is OFF, this indicates one of the three possible causes: SSR fault, B&R Controller fault or OPC Fault. If the SSR LED is ON, then either the small heater is faulty or one of its wires disconnected. 10. Check B&R BM_1 module. If its E LED is lit in red, this indicates a communication error in the B&R module or in the Ethernet line. B&R control modules BM_1 to BM_4 in unified cooler electric panel 11. Check B&R BM_2, BM_3 and BM_4 modules. If their LEDs light in red, this indicates an Ethernet communication problem. 3

  • 1
  • 2
  • 3
  • 4
  • 5
Error ID: 66115: Unified Cooler - Small heater SSR fault
FB10000 Error Messages Troubleshooting
3
7.
Ask a colleague to monitor the Small Heater SSR LED [SSR_H1] while you perform the following tests:
When cooler is idle, the SSR should be OFF, when cooler is running this Led should be lit.
SSR_H1 in Unified cooler electric panel
8.
Start the Cooler from the Service Tool application window.
9.
If the SSR LED is OFF, this indicates one of the three possible causes: SSR fault, B&R Controller fault or OPC Fault.
If the SSR LED is ON, then either the small heater is faulty or one of its wires disconnected.
10.
Check B&R BM_1 module. If its E LED is lit in red, this indicates a communication error in the B&R module or in the Ethernet line.
B&R control modules BM_1 to BM_4 in unified cooler electric panel
11.
Check B&R BM_2, BM_3 and BM_4 modules. If their LEDs light in red, this indicates an Ethernet communication problem.