HP Scitex FB10000 Geffen TS Error 66124 - Page 2

Recommended actions

Get HP Scitex FB10000 PDF manuals and user guides View all HP Scitex FB10000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

Error ID: 66124: Unified Cooler - Temperature in coolant tank is too high (over 60º C) FB10000 Error Message Troubleshooting • Large Heater/contactor is faulty (see error 66115) • Coolant flow fault error (see errors 66116 and 66125 ) (diagnostics) Recommended actions Note: Prior to starting with corrective actions, lower the tank coolant temperature below 45 °C by draining the hot coolant and then by adding cold coolant to the tank. This error is triggered when the coolant temperature exceeds 60 °C, which stops the entire system. Please take note of any additional error message that appears, pointing to other possible causes. Fan main air inlet or outlet are obstructed 1. Inspect the fan area to ensure that its air inlet and outlet are free from any obstruction. 2. Clear any obstructing object as necessary. 3. Ensure that the cooler spacer element is attached to the cooler back ensuring that it is distanced at least 30 cm from the closest wall. 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
Error ID: 66124:
Unified Cooler - Temperature in coolant tank is too high (over 60º C)
FB10000 Error Message Troubleshooting
•
Large Heater/contactor is faulty (see error 66115)
•
Coolant flow fault error (see errors 66116 and 66125 ) (diagnostics)
Recommended actions
Note:
Prior to starting with corrective actions, lower the tank coolant temperature below 45 °C by draining the hot coolant and then
by adding cold coolant to the tank. This error is triggered when the coolant temperature exceeds 60 °C, which stops the entire
system. Please take note of any additional error message that appears, pointing to other possible causes.
Fan main air inlet or outlet are obstructed
1.
Inspect the fan area to ensure that its air inlet and outlet are free from any obstruction.
2.
Clear any obstructing object as necessary.
3.
Ensure that the cooler spacer element is attached to the cooler back ensuring that it is distanced at least 30 cm from the closest wall.
2