HP Scitex FB7600 Essential Health and Safety Instructions Rev.C - Page 11

Safety Information About FB7600 Printer The FB7600 printer is a sheet-fed UV industrial flatbed digital printing press. It is mainly composed of the main chassis, loading/unloading system, flatbed printing table, printing bridge, and UV curing system. The machine prints on sheet-fed media using UV ink. There are two methods of loading substrate sheets: 3/4 Automatic loading and Manual loading. Before starting a print run, the machine operator selects the loading method in the machine software. • 3/4 Automatic loading - the substrates are placed by the machine operator on the loader table one by one and pushed towards the loader entrance. The loader aligns and feeds the substrates onto the printing table. If there is more than one copy, the second substrate is placed immediately after the loader has returned to its home position, even if the first substrate is still being printed. When the printing cycle is complete, the system automatically unloads the first substrate and stacks it on the unloader lift. Simultaneously, it feeds the second substrate onto the printing table. • Manual loading - using the machine software, the operator moves the printing table to the manual loading position and manually places the substrate sheet on the printing table against the registration pins. The operator presses the red button; the system activates the vacuum to the printing table and lowers the registration pins. The operator starts printing and after the print run is complete, manually unloads the substrate from the printing table. Installation and disassembly of the machine should be done by HP service personnel only. Recycling and disposal should be done according to the local laws and regulations. Although the product has been tested against safety standards that cover the intended use and the reasonably foreseeable misuse, the operator must avoid any misuse and always follow all the safety recommendation contained in this guide. Maintenance and replacement of spare parts should be carried out only by HP service personnel, or by a person who has been trained and authorized by HP to maintain the machine. 3