HP Server tc3100 HP Surestore Drive Rail Mounting Kit Information - Page 2
HP Server tc4100 Configuration
View all HP Server tc3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
P2 Location R2 Location Pedestal Shelf Mount Figure 1. HP Surestore Supported Locations for the HP Server tc3100 Installing the Plastic Rails (Models DAT 24i and DAT 40i) The plastic drive rails are secured to the drive by spring tension. To install the plastic drive rails: 1. Insert one end of the wire rod on the rail into the mounting hole at the rear of the drive (Figure 2). 2. Apply pressure to the middle of the rail allowing the remaining wire rod end to be inserted into the mounting hole at the front of the drive. Ensure that the rail is seated against the side of the drive. 3. Repeat the installation for the second mounting rail. Mounting Holes Insert this wire rod end first Wire Rod Ends Apply pressure to middle of rail Wire Rod Insert this wire rod end last Figure 2. Plastic Drive Rails HP Server tc4100 Configuration The HP Server tc4100 can accept any of the following HP Surestore tape drives: NOTE In any of these server configurations, the CD-ROM is normally mounted in location P1 in the pedestal configuration and in location R3 in the rack mount configuration (see Figure 3). 2 HP Part Number 5990-3463