HP StorageWorks 1606 Brocade Converged Enhanced Ethernet Administrator's Guide - Page 106
Default LLDP configuration, LLDP configuration and management, Enabling LLDP globally
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
7 Default LLDP configuration Default LLDP configuration Table 13 lists the default LLDP configuration. TABLE 13 Default LLDP configuration Parameter LLDP global state LLDP receive LLDP transmit Transmission frequency of LLDP updates Hold time for receiving devices before discarding DCBX-related TLVs to be advertised Default setting Enabled Enabled Enabled 30 seconds 120 seconds dcbx-tlv LLDP configuration and management NOTE You need to enter either the copy running-config startup-config command or the write memory command to save your configuration changes to Flash so that they are not lost if there is a system reload or power outage. Enabling LLDP globally The protocol lldp command enables LLDP globally on all interfaces unless it has been specifically disabled on an interface. LLDP is globally enabled by default. To enable LLDP globally, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to enter global configuration mode. 2. Enter LLDP configuration mode. switch(config)#protocol lldp Disabling and resetting LLDP globally The protocol lldp command returns all configuration settings made using the protocol lldp commands to their default settings. LLDP is globally enabled by default. To disable and reset LLDP globally, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to enter global configuration mode. 2. Disable LLDP globally. switch(config)#no protocol lldp 86 Converged Enhanced Ethernet Administrator's Guide 53-1001346-01