HP StorageWorks 1606 Brocade Converged Enhanced Ethernet Administrator's Guide - Page 56
Con LLDP for FCoE. For details, see, Converged Enhanced Ethernet map configuration
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
3 Minimum CEE configuration to allow FCoE traffic flow To set the minimum CEE configuration, perform the following steps in global configuration mode. 1. Configure the CEE interface as a Layer 2 switch port. For details, see "Configuring an interface port as a Layer 2 switch port" on page 42. Example of configuring the switch port as a 10-Gigabit Ethernet interface. switch(config)#interface tengigabitethernet 0/0 switch(config-if)#switchport switch(config-if)#no shutdown switch(config-if)#exit switch(config)#end 2. Create an FCoE VLAN and add an interface to it. For details, see "Configuring an interface port as an access interface" on page 42. Example of creating a FCoE VLAN and adding a single interface. switch(config)#vlan classifier rule 1 proto fcoe encap ethv2 switch(config)#vlan classifier rule 2 proto fip encap ethv2 switch(config)#vlan classifier group 1 add rule 1 switch(config)#vlan classifier group 1 add rule 2 switch(config)#interface vlan 1002 switch(conf-if-vl-1002 )#fcf forward switch(conf-if-vl-1002 )#interface tengigabitethernet 0/0 switch(config-if-te-0/0)#switchport switch(config-if-te-0/0)#switchport mode converged switch(config-if-te-0/0)#switchport mode converged allowed vlan add 1002 switch(config-if-te-0/0)#vlan classifier activate group 1 vlan 1002 switch(config-if-te-0/0)#cee default switch(config-if-te-0/0)#no shutdown switch(config-if-te-0/0)#exit 3. Create a CEE Map to carry LAN and SAN traffic and apply it to an interface. For details, see "Converged Enhanced Ethernet map configuration" on page 113. Example of creating a CEE map for 10-Gigabit Ethernet interface. switch(config)#cee-map default switch(conf-cee-map)#priority-group-table 1 weight 40 pfc switch(conf-cee-map)#priority-group-table 2 weight 60 switch(conf-cee-map)#priority-table 2 2 2 1 2 2 2 2 switch(conf-cee-map)#interface tengigabitethernet 0/2 switch(conf-if-te-0/2)#cee default switch(conf-if-te-0/2)#exit 4. Configure LLDP for FCoE. For details, see "Configuring LLDP interface-level command options" on page 91. Example of configuring LLDP for 10-Gigabit Ethernet interface. switch(config)#protocol lldp switch(conf-lldp)#advertise dcbx-fcoe-app-tlv switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv 5. Enter the copy command to save the running-config file to the startup-config file. switch(conf-lldp)#exit switch(config)#end switch#copy running-config startup-config 36 Converged Enhanced Ethernet Administrator's Guide 53-1001346-01