HP StorageWorks 1606 HP StorageWorks Fabric OS 6.3.0a release notes (5697-0359 - Page 70

Port reference provided to FICON host by Director History Buffer incorrectly references port address rather than port number. This can cause Fixed in Fabric OS 6.3.0a the host to reference the wrong port. With Fabric OS 6.2, B-series switch in interopmode 3 experiences an Fixed in Fabric OS 6.3.0a NSD panic with C-series switch in interop mode. Transient detected error on internal link caused 8-Gb blade to be faulted with reason=5. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Use slotpoweroff and slotpoweron to clear the fault. After downgrading to 6.2.0x from 6.3.0, when you execute the fwconfigure --eport --ST command runs, the threshold will be set to 63, which is not allowed in Fabric OS 6.2. Fixed in Fabric OS 6.3.0a Software verify error detected appears on console during upgrade to 6.3.0 from RC builds on HP StorageWorks 8/80 SAN Fixed in Fabric OS 6.3.0a Switch. This issue will not be seen in the field. Retransmit and Out of Order counters displayed in the portshow fciptunnel command do not show correct values. Fixed in Fabric OS 6.3.0a If the first circuit in the first tunnel is not numbered 0, portshow fciptunnel all -c displays incorrect value (adds line 16 0 un- Fixed in Fabric OS 6.3.0a knwn Disable ---- 0s 0.00 0.00 0 0/0 0). With 1606 Extension SAN Switch or Multi-protocol Extension Blade, FCIP configuration cannot be restored to default setting by using configdefault, even after chassis reboot. Fixed in Fabric OS 6.3.0a HP StorageWorks Encryption SAN Switch or encryption blade drops frames received from the host when the back-end tape becomes unresponsive. Fixed in Fabric OS 6.3.0a HP StorageWorks Multi-protocol Extension Blade faceplate image in Fixed in Fabric OS 6.3.0a Web Tools 10-GbE ports should be renamed as XGE ports. ifName value returned for xGBE port in Web Tools does not match Fixed in Fabric OS 6.3.0a CLI output. If the ITL nexus in tape (target containers with initiator) to handle multiplex/multistream environment is greater than 200, decreased performance is seen for some containers. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Reduce IT configurations (target containers with initiators) to 200. NPIV tape devices may not be seen by hosts due to name server not sending subsequent PLOGI ACC following a sequence where NPIV device sends LOGO before link down. Fixed in Fabric OS 6.3.0a GbE ports on HP StorageWorks Extension SAN Switch or Multi-protocol Extension Blade will continually showail No_Sync status if non-B-series SFP was inserted and then replaced with B-series SFP. Fixed in Fabric OS 6.3.0a Workaround prior to code change: Use portdisable and portenable after inserting the supported SFP. Copper 1-GbE SFP can get into an illegal state on Extension SAN Switch where no LED light is shown, but port is online and working. Fixed in Fabric OS 6.3.0a 70