HP StorageWorks 2/140 fw 05.01.00 and sw 07.01.00 ha-fabric manager release no - Page 15

Known Issues CTP Controls Port Lights Port lights on the edge switch and director products are controlled by the CTP functionality. Certain activities, such as FW updates, IPLing the CTP, or switching over to the backup CTP (Director) can cause these port lights to extinguish momentarily until control is reasserted by the CTP. The actual FC traffic is not affected during these times. Support for Speed Auto-Negotiate Currently, Speed Auto-Negotiate is not supported for HA and Failover SAN configurations and is not recommended in general at this time. The speed should be hard set to match the attached host or target port capability whenever possible. Regressing to an Earlier HAFM Code When regressing to earlier HAFM code versions (pre-06.00.01-04), 2 Gbps products currently installed will drop from the HAFM screen because earlier Product Managers cannot support the expanded features and have different naming conventions. Switches can be re-added by IP or by restoring the original configuration when the FW/SW level again supports 2 Gbps switches. The fabric/zoning information will remain intact. Once the HAFM server is upgraded to version 07.01.00-09, any downgrade of the HAFM server to a release earlier than version 06.03.00 will result in the loss of saved firmware files in the HAFM Firmware Library. The desired firmware must be reloaded into the Firmware Library. Installing HAFM on an Existing HP EFCM or SDCM Server Installation of HAFM on an existing HP EFCM or SDCM server will successfully migrate the older data files into the new configuration. Refer to the HP StorageWorks Director FC-64 to Director 2/64 Upgrade Instructions, A6574-96003/AA-RSS1A-TE or HP StorageWorks Director 64 to Director 2/64 Upgrade Instructions, AA-RT4JA-TE. HA-Fabric Manager Release Notes 15