HP StorageWorks 2/140 FW 05.02.00 and SW 07.01.00 and 07.02.00 HP StorageWorks - Page 4

Release Notes Information, A Device Cannot Send Frames to Itself After the Active Zone Set Is

Page 4 highlights

Release Notes Information Release Notes Information These Release Notes cover the following major topics: ■ Embedded Web Server access to modify zones is limited to first 255 zones, page 19 ■ SNMP trap reports incorrect FRU position, page 19 ■ Director 2/140 Maintenance Port Baud Rate may be Set Incorrectly, page 20 ■ Downgrading Firmware in Director 2/140 may Cause Database Event, page 20 ■ Upgrading Firmware in Director 2/64 may Time-out if Very Busy, page 20 ■ HSG80 Transparent Mode Not Supported with IBM AIX, page 21 ■ HSG80 Transparent Mode Not Recommended with Controller in SCSI-3 Mode with HP-UX Operating Systems, page 21 ■ ISL Disconnect Causes NOS Error with the OpenVMS Operating Systems, page 21 ■ Support for Speed Auto-Negotiate, page 22 ■ Ports May Accumulate Spurious Events, page 22 ■ IML is Required After Performing a Configuration Reset, page 22 ■ Error Can Be Caused if Port Speed is Changed Simultaneously for All Ports of a Director 2/140, page 23 ■ Adding a Defective ISL Connection May Cause all ISLs to Segment Between the Two Switches or Directors, page 23 ■ Possible Switch Reset After Power Failure or Power Off Sequence, page 23 ■ Erroneous Error Message When No Firmware File Selected, page 24 ■ A Device Cannot Send Frames to Itself After the Active Zone Set Is Deactivated, page 24 ■ False SBAR Failure in Director 2/64 Under Very High Fibre Channel Traffic, page 24 4 Director Release Notes

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Release Notes Information
4
Director Release Notes
Release Notes Information
These Release Notes cover the following major topics:
Embedded Web Server access to modify zones is limited to first 255 zones
,
page 19
SNMP trap reports incorrect FRU position
, page 19
Director 2/140 Maintenance Port Baud Rate may be Set Incorrectly
, page 20
Downgrading Firmware in Director 2/140 may Cause Database Event
,
page 20
Upgrading Firmware in Director 2/64 may Time-out if Very Busy
, page 20
HSG80 Transparent Mode Not Supported with IBM AIX
, page 21
HSG80 Transparent Mode Not Recommended with Controller in SCSI-3
Mode with HP-UX Operating Systems
, page 21
ISL Disconnect Causes NOS Error with the OpenVMS Operating Systems
,
page 21
Support for Speed Auto-Negotiate
, page 22
Ports May Accumulate Spurious Events
, page 22
IML is Required After Performing a Configuration Reset
, page 22
Error Can Be Caused if Port Speed is Changed Simultaneously for All Ports
of a Director 2/140
, page 23
Adding a Defective ISL Connection May Cause all ISLs to Segment Between
the Two Switches or Directors
, page 23
Possible Switch Reset After Power Failure or Power Off Sequence
, page 23
Erroneous Error Message When No Firmware File Selected
, page 24
A Device Cannot Send Frames to Itself After the Active Zone Set Is
Deactivated
, page 24
False SBAR Failure in Director 2/64 Under Very High Fibre Channel Traffic
,
page 24