HP StorageWorks 2/16N Brocade Access Gateway Administrator's Guide - Supportin - Page 25
To enable Access Gateway mode from the CLI, switchShow, switchDisable, ag --modeEnable, configUpload
View all HP StorageWorks 2/16N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Enabling Access Gateway mode 2 To enable Access Gateway mode from the CLI 1. Connect and log in to the switch. 2. Enter the switchShow command to display the current switch configuration. The example below shows a switch in the Fabric OS Native mode (where switchMode equals Native). switch:admin> switchshow switchName: switch switchType: 43.2 switchState: Online switchMode: Native switchRole: Principal switchDomain: 1 switchId: fffc01 switchWwn: 10:00:00:05:1e:03:4b:e7 zoning: OFF switchBeacon: OFF Area Port Media Speed State Proto 0 0 -- N4 No_Module 1 1 cu N4 Online F-Port 50:06:0b:00:00:3c:b7:32 2 2 cu N4 Online F-Port 10:00:00:00:c9:35:43:f5 3 3 cu AN No_Sync 4 4 cu AN No_Sync Disabled (Persistent) 5 5 cu N4 Online F-Port 50:06:0b:00:00:3c:b4:3e 6 6 cu N4 Online F-Port 10:00:00:00:c9:35:43:f3 7 7 cu AN No_Sync Disabled (Persistent) 8 8 cu AN No_Sync 9 9 cu AN No_Sync Disabled (Persistent) 10 10 cu AN No_Sync Disabled (Persistent) 11 11 cu AN No_Sync Disabled (Persistent) 12 12 cu AN No_Sync Disabled (Persistent) 13 13 cu AN No_Sync Disabled (Persistent) 14 14 cu AN No_Sync Disabled (Persistent) 15 15 cu AN No_Sync Disabled (Persistent) 16 16 cu AN No_Sync Disabled (Persistent) 17 17 -- N4 No_Module 18 18 -- N4 No_Module 19 19 -- N4 No_Module 20 20 -- N4 No_Module 21 21 id N4 Online E-Port segmented,(zone conflict)(Trunk master) 22 22 id N4 Online E-Port (Trunk port, master is Port 21 ) 23 23 id N4 Online E-Port (Trunk port, master is Port 21 ) 3. Enter the switchDisable command to disable the switch. switch:admin> switchdisable Note To save the switch configuration, use the configUpload command before proceeding with the next step. 4. Enter the ag --modeEnable command to enable Access Gateway mode. switch:admin> ag --modeenable The switch automatically reboots and comes back online in Access Gateway mode using a factory default F_Port to N_Port mapping. See Appendix A, "Default Port Mapping". Access Gateway Administrator's Guide 2-5 Publication Number: 53-1000430-01