HP StorageWorks 2300 HP StorageWorks Disk System 2300 User's Guide(This manual - Page 92
Supported Operating Systems, Installing CommandView SDM, HP-UX, Installation, HP Command
View all HP StorageWorks 2300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Supported Operating Systems The HP Command View SDM software is supported on the operating systems listed below. Both the HP Command View SDM software and the Upgrade License software products are supported on these operating systems. Minimum system requirements for each operating system are identified in this section, prior to the installation instructions for each operating system. ■ HP-UX 11.00 (for most current Support Plus patches, see HP-UX Installation) ■ HP-UX 11.11 (for most current Support Plus patches, see HP-UX Installation) ■ Windows NT 4.0 (Service Pack 6a or greater) ■ Windows 2000 (Service Pack 1 or greater) ■ Linux Redhat 6.2 and 7.0 New product support is continually being added for HP disk systems, such as new operating system support, hardware configurations (Hosts/HBAs), firmware upgrades, plus additional software products. To obtain the most current support and product information, access the HP web site. Installing CommandView SDM For specific installation instructions for your operating system, see HP Command View SDM Disk System Installation and User Guide Version 1.04, part number T1001-96006. For Windows 2000 installation only: After the disk system is properly connected and Windows has been started, follow the procedure below after the "Found new Hardware" pop-up dialog appears: 1 Select "Search for drivers" and click "Next". 2 Check the specify location check box, and click "Next". 3 Click on the "Browse" button. 4 Use the file browser to locate and select the DS2300.inf file on the Command View SDM CD in the \drivers\win directory (i.e. d:\drivers\win\DS2300.inf). Click "OK". 5 Click the next button to install the .inf file. 92 Configuration