HP StorageWorks 4/256 Brocade Fabric OS Message Reference - Supporting Fabric - Page 130
EM-1045, EM-1046, EM-1047
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
11 EM-1045 EM-1045 Message , [EM-1045], ,, WARNING, , is being powered . Probable Cause Indicates that an automatic power adjustment is being made because of the (predicted) failure of a power supply or the insertion or removal of a port blade. If new_state is On, a port blade is being powered on because more power is available (either a power supply was inserted or a port blade was removed or powered down). If new_state is Off, a port blade has been powered down because a power supply has been faulted, because it is indicating a predicted failure. If new_state is Down (not enough power), a newly inserted port blade was not powered on because there was not enough power available. Recommended The Brocade 24000 requires only a single power supply for a fully populated chassis; however, you Action should always operate the system with at least two power supplies for redundancy. Severity WARNING EM-1046 Message , [EM-1046], ,, WARNING, , Sysctrl reports error status for blade ID for the blade in slot Probable Cause Indicates that the system controller encountered a blade with an unknown ID in the slot specified. Recommended Action If the blade ID listed is not correct, then the field-replaceable unit (FRU) header for the blade is corrupted and the blade must be replaced. For the Brocade 24000, the blade ID should be 5 for a control processor (CP) blade and 4 for a port blade. Severity WARNING EM-1047 Message , [EM-1047], ,, INFO, , CP in slot not faulty, CP ERROR deasserted. Probable Cause Indicates that the control processor (CP) is no longer faulted. This message usually follows EM-1033. The new standby CP is in the process of rebooting and has turned off the CP_ERR signal. Recommended No action is required. Action Severity INFO 82 Fabric OS Message Reference 53-1000437-01