HP StorageWorks 4/256 Brocade Fabric OS Message Reference - Supporting Fabric - Page 537
Sulb-1021, Sulb-1023, Sulb-1024
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 537 highlights
83 SULB-1021 Probable Cause The BP blade should reboot with the new image, but is still running the old image. This error may indicate that the new image has not been loaded correctly to the specified blade. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1021 Message AUDIT, , [SULB-1021], WARNING, FIRMWARE, , , , Firmware is being downloaded to the blade in slot . Probable Cause Indicates that the firmware is being loaded to the specified blade. Recommended Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it Action finishes, run the firmwareShow command to verify the firmware versions. Severity WARNING SULB-1023 Message AUDIT, , [SULB-1023], WARNING, FIRMWARE, , , , The blade in slot has rebooted during firmwaredownload. Probable Cause The error may be caused by an unexpected disruption of the firmwareDownload command, for example, by powering off and on of the indicated BP blade in the middle of a firmwareDownload. The error may also be caused by persistent storage hardware failure or by a software error. Recommended Action firmwareCommit will be started automatically after the blade boots up to repair the secondary partition. If at the end of firmwareCommit, the blade firmware version is still inconsistent with the active CP firmware, firmwareDownload will automatically be restarted on the blade. Run the firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your switch service provider. Severity WARNING SULB-1024 Message Probable Cause AUDIT, , [SULB-1024], WARNING, FIRMWARE, , , , Firmware commit has completed on the blade in slot . Indicates that the firmwareCommit operation has completed on the specified blade. Fabric OS Message Reference 489 53-1000437-01