HP StorageWorks 4/64 HP StorageWorks DC and DC04 SAN Backbone Director Switche - Page 173
Installing a blade, DC04 SAN Director blade FC8-48 shown
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
11. FC8-16, FC8-32, FC8-48 blades: Open the ejectors. Pull the blade out of the chassis using the ejectors. FC10-6 and FR4-18i blades: Unscrew the two thumb screws from the top and bottom ejectors on the blade using the Phillips screwdriver. Open both ejectors simultaneously to approximately 45 degrees and pull the blade out of the chassis. 12. If the blade is not being replaced by another blade, install a filler panel. Figure 65 DC04 SAN Director blade (FC8-48 shown) Installing a blade Slots are numbered from 1 through 8, from bottom to top when facing the port side of the DC04 SAN Director. Port and application blades can be installed in slots 1-2 and 7-8. CAUTION: Wear a grounded ESD strap when handling a blade. Use the grounding connections above the power connectors on the chassis. 1. Orient the blade so that the ports are at the front of the chassis and the flat side of the blade is on the left. See Figure 65. HP StorageWorks DC and DC04 SAN Backbone Director Switches 173