HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 28
Resolve any other IP Security, the Fibre Channel FC port
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1005.0070) (Hotreset to older firmware version not supported. A reset is required to activate this version of firmware) The installed firmware cannot Perform a hard reset. be activated without disrupting I/O traffic. (A1005.0071) (Unable to obtain dynamic IP address, falling back to static IP address of address on interface interface) The switch was unable to obtain its IP address from the Dynamic Host Configuration Protocol (DHCP) server. The static IP address will be used. Investigate the DHCP server. (A1005.0072) (Unable to turn off lasers, please power off the switch) Conditions exist that could damage the switch and the switch was unable to turn off the Fibre Channel (FC) port lasers. Power down the switch and contact your authorized maintenance provider. (A1005.009B) (IPSec configuration error: error_description) An error occurred while saving changes to an IP security configuration. None of the configuration modifications have been applied to the switch's active database. Resolve any other IP Security alarms. If this alarm persists, contact your authorized maintenance provider. (A1005.009C) (IPSec An error occurred affecting Redo modifications to the configuration error: the specified association association and save the IP v Association while saving the IP security security configuration. assocation_name : error_description configuration. The association has not been applied to the active database. (A1005.009D) (IPSec configuration error: Policy policy_name : reason) An error occurred affecting the specified policy while saving the IP security configuration. The policy has not been applied to the active database. Redo modifications to the policy and save the IP security configuration. (A1005.0101) (ipv6: duplicate address detected) Another IP version 6 system on the local network is using the same address as this switch. Assign a different IPv6 address (if static), or disconnect the system that is using the same address. (A1006.0004) (Zoning conflict, device_WWN is in an ACL hard zone, but device_WWN share a soft zone) (A1006.0005) (Zoning enforcement error in Nameserver) The named zone members cannot communicate because they are members of different hard zones. Place both zone members in the same hard zone or exclude both from hard zones. An error occurred while checking hard zoning. Contact your authorized maintenance provider. 28