HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 35

Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1007.0039) (Ignoring RADIUS Server server, no shared secret configured) (A1007.003A) (Using local user authentication. No radius servers configured for user authentication) An attempt was made to authenticate a switch login through a Remote Authentication Dial In User Service (RADIUS) server, but no shared secret exists. Configure a shared secret. A Remote Authentication Dial In User Service (RADIUS) configuration was set to authenticate user accounts through a RADIUS server, but no RADIUS server was configured. User accounts will be authenticated by the switch. Correct the user authentication order or configure a RADIUS server. (A3000.0001) (Temp overheat, sensor_name sensor reads value C ALARM SET) The chassis temperature has reached a failure threshold. Check air flow, fan operation, and ambient temperature. If the problem cannot be corrected, power down the switch. (A3001.0001) (Temp overwarm, sensor_name sensor reads value C ALARM SET) The chassis temperature has Check air flow, fan operation, reached a warning threshold. and ambient temperature. (A3002.0001) (sensor name sensor has returned to normal range - ALARM CLEARED) The chassis temperature has returned to the normal range and the alarm condition has been cleared. None (A3003.0001) (IOn) (Hardware error detected. Use 'show switch' for more info.) A fatal hardware error was discovered during the Power-on Self Test (POST) phase of startup. This switch is not currently operational. Enter the show post log command to investigate. (A3003.0002) (POST detected a fatal error the last time it ran and will be re-executed.) A fatal hardware error was discovered from the previous Power-on Self Test (POST). This switch is not currently operational. Enter the show post log command to investigate. (A3004.0001) (Non-fatal hardware error detected. Use 'show post log' for more info) (A3005.0001-000C) (value voltage sensor shows valueV - ALARM SET) (A3006.0001-000C) (value voltage sensor shows valueV - ALARM SET) A non-fatal hardware error was discovered during the Power-on Self Test (POST) phase of startup. A switch voltage sensor is experiencing an out-of-range voltage condition. An out-of-range voltage condition has occurred. Enter the show post log command to investigate. Contact your authorized maintenance provider. Contact your authorized maintenance provider. 8/20q Fibre Channel Switch event messages reference guide 35