HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 32

Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1007.0022) (Invalid response authenticator from RADIUS server IP_address:port, check shared secret) There is a Remote Authentication Dial In User Service (RADIUS) server configuration issue. Verify that the shared secret is configured on both the RADIUS server and the switch. (A1007.0023) (Invalid response authenticator from RADIUS server IP_address:port, check shared secret There is a Remote Authentication Dial In User Service (RADIUS) configuration problem. Confirm that the shared secret configured on the switch is identical to the shared secret configured on the RADIUS server. (A1007.0024) (Invalid access accept from RADIUS server IP_address:port, bad or missing Service-Type) A service-type Remote Authentication Dial In User Service (RADIUS) attribute was not found in a RADIUS packet. This is a RADIUS server configuration issue. Consult your RADIUS server documentation. (A1007.0025) (Security feature not supported.) The switch is coming out of Non-Disruptive Code Load and Activation (NDCLA) and had an active security prior to the NDCLA, but the security feature is no longer supported. A license key may be required for the security feature. (A1007.0026) (Unable to validate Chap Response from device_WWN, possible Chap secret misconfiguration or security breach attempt.) A Challenge Handshake Authentication Protocol (CHAP) authentication attempt failed due to failure while comparing secrets. Check security configuration. (A1007.0027) (Radius server could not validate authentication response from port_number) A Remote Authentication Dial In User Service (RADIUS) authentication failed. Confirm that the secret is the same on the switch as it is on the RADIUS server. (A1007.0028) (Security: 2-Way Authentication, No security entry found for port) Unable to locate a security member entry to complete a two-way authentication. Edit the group to include the port. (A1007.0029) (Security protocol not using chap, unable to authenticate.) A Challenge Handshake Authentication Protocol (CHAP) negotiate frame that specifies an unsupported authentication protocol was received. Check the remote device for a possible error condition. Reset the port to try again. If errors continue, disable CHAP for this device if the device belongs in the fabric. (A1007.002A) (Inconsistent Fabric Binding configuration. Enabled on remote switch(s), disabled on local switch. Inconsistent fabric binding configuration settings between the local and remote switch. All switches in the fabric must have the same fabric binding setting. Enable or disable fabric binding on all switches. 32