HP StorageWorks SN6000 HP StorageWorks Simple SAN Connection Manager user guid - Page 20
Configuring Simple SAN Connection Manager for HP-UX and Emulex HBAs, HP-UX configuration
View all HP StorageWorks SN6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
4. If the following message appears at the end of the installation, you must restart the computer, otherwise, continue with step 6: New driver and qlremote installed but not active. For new driver and qlremote to be active either: Reboot the system (Mandatory in case of Boot From SAN) or Stop all the applications using QLogic driver. Unload QLogic driver by executing following command: # modprobe -r qla2XXX (ex. qla2300, qla2400) Reload new driver by executing following command: # modprobe -v qla2xxx Start qlremote as follows: # /etc/init.d/qlremote start Rebooting the system will automatically load new driver and start qlremote. 5. To install the Linux driver with Fabric Device Management Interface (FDMI) enabled (by default, FDMI is disabled), issue the following command: # modprobe -v qla2xxx ql2xfdmienable=1 6. To verify that the installation completed, check the FC HBA driver version: a. To ensure that the driver is installed in the correct location, issue the following command: # modinfo qla2xxx The following is returned: Filename: /lib/modules/2.6.9-55.ELsmp/kernel/drivers/scsi/qla2xxx/qla2xxx.ko Version: 8.02.02 653675A771C3619AEEA4E9A b. To verify that the driver is loaded, issue the following command: # lsmod | grep qla2xxx The following is returned: qla2xxx_conf 303752 qla2xxx 982688 scsi_mod 445298 1 0 qla2xxx c. To verify that the correct driver is loaded, issue the following command: # cat /proc/scsi/qla2xxx/* | grep "Driver version" The following is returned: Firmware version: 3.03.25 IPX Driver version: 8.02.02-fo Configuring Simple SAN Connection Manager for HP-UX and Emulex HBAs Simple SAN Connection Manager is compatible with the HP-UX operating system and Emulex HBAs when configured as described in this section. HP-UX configuration Simple SAN Connection Manager can manage all of your supported HP-UX servers. The HP-UX operating system provides native software drivers for the HP StorageWorks FC HBAs. In order for the application to properly identify your server(s), you must manually enter the Fabric Device Management Interface (FDMI) information when the application prompts for it. For details, see Manually entering FDMI information on page 81. Emulex HBA configuration Simple SAN Connection Manager can manage all of your supported Windows and Linux servers that have Emulex HBAs installed. In order for the application to properly identify your server(s), you must set the 20 Installing, upgrading, and removing Simple SAN Connection Manager