HP StoreEver LTO-5 Ultrium SB3000c HP StorageWorks Tape Blade User Guide (6250 - Page 57
Keeping eject button pressed down, power on in OBDR mode
![]() |
View all HP StoreEver LTO-5 Ultrium SB3000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
2. Power on the blade server for approximately 3 seconds then power off. This will reset the Tape Blade. Immediately hold down the eject button on the tape drive to invoke OBDR. Release the button as soon as the Ready LED on the front panel flashes in the OBDR sequence. This is a repeated flashing pattern. Once the Tape Blade is in OBDR mode, power on the blade server again. Figure 25 Keeping eject button pressed down, power on in OBDR mode . Keyboard shortcut for HP ProLiant servers There is no need to press the Eject button. Just power on your server and press the [F8] function key during the Power On Self Test (POST). This invokes OBDR to restore your system. For more information and specific instructions please refer to our World Wide Web site at http:// www.hp.com/go/obdr. NOTE: The firmware for the embedded SC44Ge HBA may need to be upgraded to the latest version in order to take advantage of this feature. 3. Follow the on-screen instructions to restore your system. Once the operating system has been restored and rebooted, you may remove the backup cartridge. Tape Blade 57
![](/manual_guide/products/hewlettpackard-storageworks-sb920c-hp-storageworks-tape-blade-user-guide-625055001-2010-be5f83a/57.png)