HP StoreOnce D2D4324 HP StoreOnce Backup System Concepts and Configuration Gui - Page 96
Seeding using physical tape and backup application, to 2 TB
View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Figure 53 Seeding using physical tape and backup application 1. Initial backup to StoreOnce appliance 3. Ship tapes/disks to Data Center site. 5. Establish replication. 2. Copy to tape(s) or a disk using backup application software on Media Server for NAS devices; only use simple drag and drop to portable disk This technique is not possible at Sites A & B unless a media server is present. 4. Copy tapes/disks into target appliance using backup application software on Media Server (or for portable disks only use drag and drop onto NAS share on the StoreOnce target). Proceed as follows 1. Perform full system backup to the StoreOnce Backup system at the remote site using the local media server, e.g. at remote site C. The media server must also be able to see additional devices such as a physical LTO tape library or a removable disk device configured as a disk target for backup. 2. Use the backup application software to perform a full media copy of the contents of the StoreOnce Backup system to a physical tape or removable disk target for backup also attached to the media server. In the case of removable USB disk drives the capacity is probably limited to 2 TB, in the case of physical LTO5 media it is limited to about 3 TB per tape, but of course multiple tapes are supported if a tape library is available. For USB disks, separate backup targets for disk devices would need to be created on each removable RDX drive because we cannot span multiple RDX removable disk drives. 3. The media from the remote sites is then shipped (or even posted!) to the data center site. 4. Place the removable media into a library or connect the USB disk drive to the media server and let the media server at the data center site discover the removable media devices. The media server at the data center site typically has no information on what is on these pieces of removal media and we have to make the data visible to the media server at the data center site. This generally takes the form of what is known as an "import" operation where the 96 Seeding methods in more detail