HP Stream Notebook - 11-d010wm HP Stream Notebook PC (model numbers 11-d000 th - Page 37

by sliding it up and forward at an angle., Remove the keyboard/top cover

Get HP Stream Notebook - 11-d010wm PDF manuals and user guides View all HP Stream Notebook - 11-d010wm manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

11. Release the zero insertion force (ZIF) connector (4) to which the keyboard cable is attached, and then disconnect the keyboard cable from the system board. 12. Release the ZIF connector (5) to which the power button board cable is attached, and then disconnect the power button board cable from the system board. 13. Release the ZIF connector (6) to which the TouchPad cable is attached, and then disconnect the TouchPad cable from the system board. 14. Remove the keyboard/top cover (7) by sliding it up and forward at an angle. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system board components each time the heat sink is removed. Replacement thermal material is included with the heat sink and system board spare part kits. The following illustration shows the replacement thermal material locations on the system board (1) and the heat sink (2). Component replacement procedures 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
11.
Release the zero insertion force (ZIF) connector
(4)
to which the keyboard cable is attached, and then
disconnect the keyboard cable from the system board.
12.
Release the ZIF connector
(5)
to which the power button board cable is attached, and then disconnect
the power button board cable from the system board.
13.
Release the ZIF connector
(6)
to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the system board.
14.
Remove the keyboard/top cover
(7)
by sliding it up and forward at an angle.
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system
board components each time the heat sink is removed. Replacement thermal material is included with the
heat sink and system board spare part kits.
The following illustration shows the replacement thermal material locations on the system board
(1)
and the
heat sink
(2)
.
Component replacement procedures
31