HP Surestore Disk Array 12h Controller Module Installation Guide - Page 15

System State: Not Enough Disks

Get HP Surestore Disk Array 12h - And FC60 PDF manuals and user guides View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

5. Shutdown the array using the front panel. KEY CANCEL CANCEL MENU ENTER ENTER DISPLAY "Ready" "Language" "View Settings" "Shutdown" "Confirm" "Shutdown Complete" After shutdown has completed, push the on/off button to the off position completing the shutdown. This will turn off power to all modules. 6. Disconnect all disk drive modules from the back plane. You do not need to remove them completely. Just pull them out so that the cam handle is fully extended. 7. Remove the controller that was noted as primary in one of the previous steps. 8. Install the "third" controller into slot X. This may mean that you have to move the existing controller into slot Y. 9. Push the on/off button to the on position and allow the array to complete its initialization process. After the initialization has completed, the front panel should say "Not Enough Disks". Check the system state using the key strokes below. The System state should be "Not Enough Disks" with a "Firmware Needed" warning. KEY CANCEL CANCEL MENU - ENTER + DISPLAY "Not Enough Disks" "Language" "View Settings" "System State: Not Enough Disks" "Warning: Firmware Needed" 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
15
5.
Shutdown the array using the front panel.
KEY
DISPLAY
CANCEL CANCEL
“Ready”
MENU
“Language”
-
“View Settings”
-
“Shutdown”
ENTER
“Confirm”
ENTER
“Shutdown Complete”
After shutdown has completed, push the on/off button to the off position completing the
shutdown. This will turn off power to all modules.
6.
Disconnect all disk drive modules from the back plane. You do not need to remove them completely.
Just pull them out so that the cam handle is fully extended.
7.
Remove the controller that was noted as primary in one of the previous steps.
8.
Install the “third” controller into slot X. This may mean that you have to move the existing controller
into slot Y.
9.
Push the on/off button to the on position and allow the array to complete its initialization process. After
the initialization has completed, the front panel should say “Not Enough Disks”. Check the system state
using the key strokes below. The System state should be “Not Enough Disks” with a “Firmware
Needed” warning.
KEY
DISPLAY
CANCEL CANCEL
“Not Enough Disks”
MENU
“Language”
–
“View Settings”
ENTER
“System State: Not Enough Disks”
+
“Warning: Firmware Needed”