HP Surestore Disk Array 12h Controller Module Installation Guide - Page 16

then Offline SCSI ID

Get HP Surestore Disk Array 12h - And FC60 PDF manuals and user guides View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

10. Verify if the primary controller currently installed has the desired firmware using the front panel display. The following table shows the proper front panel commands to view which controller is the primary array controller, and what version of firmware is on the primary array controller. KEY CANCEL CANCEL MENU - ENTER + + + + + DISPLAY "Not Enough Disks" "Language" "View Settings" "System State: Not Enough Disks" "Warning: Firmware Needed" "Primary Cntrl: X" "SCSI ID x: ___" "SCSI ID y: ___" "Firmware: HP__" 11. Copy the firmware from the primary controller to the secondary controller using the front panel: KEY CANCEL CANCEL MENU + ENTER - ENTER ENTER DISPLAY "Not Enough Disks" "Language" "Cntrl Changes" "SCSI ID" "Copy Firmware" "Confirm" "Copying Firmware", then "Firmware Loading", then array will initialize then "Offline SCSI ID" 12. The front panel display should say "Not Enough Disks". Check the "System State" on the front panel display. It should say "Not Enough Disks" with no other warnings. KEY CANCEL CANCEL MENU - ENTER + DISPLAY "Not Enough Disks" "Language" "View Settings" "System State: Not Enough Disks" "Primary Cntrl: X" 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
16
10. Verify if the primary controller currently installed has the desired firmware using the front panel
display. The following table shows the proper front panel commands to view which controller is the
primary array controller, and what version of firmware is on the primary array controller.
KEY
DISPLAY
CANCEL CANCEL
“Not Enough Disks”
MENU
“Language”
–
“View Settings”
ENTER
“System State: Not Enough Disks”
+
“Warning: Firmware Needed”
+
“Primary Cntrl: X”
+
“SCSI ID x: ___”
+
“SCSI ID y: ___”
+
“Firmware: HP__”
11. Copy the firmware from the primary controller to the secondary controller using the front panel:
KEY
DISPLAY
CANCEL CANCEL
“Not Enough Disks”
MENU
“Language”
+
“Cntrl Changes”
ENTER
“SCSI ID”
–
“Copy Firmware”
ENTER
“Confirm”
ENTER
“Copying Firmware”,
then “Firmware Loading”,
then array will initialize
then “Offline SCSI ID”
12. The front panel display should say “Not Enough Disks”. Check the “System State” on the front panel
display. It should say “Not Enough Disks” with no other warnings.
KEY
DISPLAY
CANCEL CANCEL
“Not Enough Disks”
MENU
“Language”
–
“View Settings”
ENTER
“System State: Not Enough Disks”
+
“Primary Cntrl: X”