HP Surestore Tape Library Model 2/28 HP DLT Tape Library 28/48-Slot - User& - Page 34
Step 4: Connect the Library to the Host, Table 2-3, Drive SCSI Connection Options, Library Model
View all HP Surestore Tape Library Model 2/28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Library Installation Step 4: Connect the Library to the Host Step 4: Connect the Library to the Host 1. Ensure that the host has been properly shut down and powered off. 2. Remove the back panel (lift up on the bottom of the panel, then pull it away). 3. Use SCSI cables to connect the drives to the host, as explained in the following table. Table 2-3 Library Model DLT4000 2/28 DLT4000 4/48 DLT7000 2/28 DLT7000 4/48 Drive SCSI Connection Options SCSI Configuration Non-daisy chained Daisy chained Connect drive ports 1 and 2 to Connect drive ports 1 and 2 together; their own host SCSI cards. connect to a single host SCSI card. Connect drive ports 1, 2, 3, and Connect drive ports 1 and 2 together; 4 to their own host SCSI cards. connect to a single host SCSI card. Connect drive ports 1 and 2 to their own host SCSI cards. Connect drive ports 1, 2, 3, and 4 to their own host SCSI cards. Connect drive ports 3 and 4 together; connect to a single host SCSI card. Not supported Not supported 4. Connect the library (bus 0) to a dedicated host SCSI card. NOTE Connecting other peripherals to the library or drive buses is not supported. 2-6