HP T5730 Troubleshooting Guide: HP t5730 and t5735 Thin Client - Page 17

Installing the USB Device, Replacing the Secure USB Compartment Cover

Get HP T5730 - Compaq Thin Client PDF manuals and user guides
UPC - 883585485772
View all HP T5730 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

4. Remove the cover from the unit by first lifting the rear (screw side) of the cover, and then lifting the cover off the unit (3). Installing the USB Device Before beginning the replacement process, review General Hardware Installation Sequence on page 7 for procedures you should follow before and after installing or replacing hardware. ▲ Insert the USB device into the USB port in the secure USB compartment. See the following illustration for the location of the ports in the secure USB compartment. Replacing the Secure USB Compartment Cover To replace the secure compartment cover: 1. Place the cover on top of the unit so it is offset about 1.27 cm (1/2 inch) toward the rear of the unit, allowing the tabs on the cover to align and insert into the slots on the chassis (1). 2. Slide the cover toward the front of the unit until it locks in place and the cover is flush with the front panel of the chassis (2). Removing and Replacing the Secure USB Compartment Cover 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
4.
Remove the cover from the unit by first lifting the rear (screw side) of the cover, and then lifting the
cover off the unit
(3)
.
Installing the USB Device
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
7
for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Replacing the Secure USB Compartment Cover
To replace the secure compartment cover:
1.
Place the cover on top of the unit so it is offset about 1.27 cm (1/2 inch) toward the rear of the unit,
allowing the tabs on the cover to align and insert into the slots on the chassis
(1)
.
2.
Slide the cover toward the front of the unit until it locks in place and the cover is flush with the front
panel of the chassis
(2)
.
Removing and Replacing the Secure USB Compartment Cover
9