HP Tc2110 hp server ultra3 SCSI HBA installation guide for tc2110 (English) - Page 54
adpt160m.ham Command Line Options, Table 5-1., Option, Values, Default, Description
View all HP Tc2110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 5 Novell NetWare Installation adpt160m.ham Command Line Options Table 5-1. adpt160m.ham Command Line Options Option auto_disable_tagq= dev_enable= flush_diskreq= instr= lun_enable=1 max_tags= Values on, off Default off 0-FFFF FFFF 0-FFFF 0 on, off off 0-FF 01 1-128 16 Description Enables/disables auto disable tagged queuing algorithm. Allows you to enable the driver's registration of SCSI devices on a per target basis. By default, all targets are scanned. A bit value of 0 causes the target not to register under the operating system. These devices are still accessible via ASPI. This enable bit mask is entered in hex (see "Bit Mask Options" on page 49). A bit mask to send occasionally ordered tags to specific targets. By default, no targets receive occasionally ordered tags. This bit mask is entered in hex (see "Bit Mask Options" on page 49). Enables/disables recording of I/ O statistics. A bit mask to enable scanning for specific LUNs on all targets. The default value of 01 causes the driver to scan LUN 0 only. This enable bit mask is entered in hex (see "Bit Mask Options" on page 49.) Specifies maximum number of tagged commands per device. 48