HP Vectra XE320 hp vectra xe320, upgrade guide - Page 24

Upgrading and Replacing PC Hardware, SLAVE, MASTER, If this is the only device

Get HP Vectra XE320 PDF manuals and user guides View all HP Vectra XE320 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Upgrading and Replacing PC Hardware 3 Check that the jumpers on the rear of the new drive are set to CS (cable select) mode. 4 Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above. 5 Tighten the two screws that fasten the drive to the bay. 6 Connect the data and power cables, and for DVD or CD-ROM drives on Linux models, the audio cable. • If this is the second device installed in the expansion bays, fit the data connector marked SLAVE. • If this is the only device, fit the end CD connector marked MASTER. audio cable (only required for Linux models) 7 Replace the PC's side panel (refer to "Removing and Replacing the Side Panel" on page 12). 8 Reconnect the power cord. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Upgrading and Replacing PC Hardware
24
3
Check that the jumpers on the rear of the new drive are set to CS (cable select) mode.
4
Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above.
5
Tighten the two screws that fasten the drive to the bay.
6
Connect the data and power cables, and for DVD or CD-ROM drives on Linux models, the audio cable.
•
If this is the second device installed in the expansion bays, fit the data connector marked
SLAVE
.
•
If this is the only device, fit the end CD connector marked
MASTER
.
7
Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).
8
Reconnect the power cord.
audio cable (only
required for Linux
models)