HP Vectra XU 6/XXX HP Vectra XU 6/xxx and VT 6/xxx PCs - Technical Reference M - Page 46

05F0 0600..06FE 06FF 0700 0800 0801 0811 0812 0813 0814 0815 0816 0817 081A 0900 0910 1100..110F, 1200..120F 20xA 201B, 202B, 204B, 208B 201C, 202C, 204C, 208C 2110..212F, 2210..221F 4F00..4F0F 6100..61FF, 6500, 8x06 62F1 6510, 6520 65C0..65DF 6600..66FF 6700 7000..7FFF The built-in I/O controller's address is used by an accessory board. The following devices may not function properly: keyboard, mouse, serial and parallel ports, flexible disk drives, configuration information (serial EEPROM and CMOS RAM), real-time-clock, and configuration switches. One of the keys on the keyboard is stuck or a key was pressed during the power-on self-test. The mouse is connected to the keyboard port. The audio system cannot be initialized. The ROM on an accessory board uses the same address (E000h) as the system board's boot ROM. The boot ROM is enabled in Setup but a boot ROM is not present in the computer. The Integrated Ethernet Interface cannot be found at the I/O base address specified in Setup. The MAC address of the Integrated LAN Interface is corrupted. The Integrated Ethernet Interface registers cannot be initialized. The Integrated Ethernet Interface DMA transfer cannot be initialized. The Integrated Ethernet Interface internal registers read and write test failed. The Integrated Ethernet Interface configuration information is corrupted. The EEPROM containing the configuration parameters of the LAN Interface is corrupted. The Integrated Ethernet Interface internal loopback test failed. The microprocessor fan is not connected. *** WARNING *** This could result in damage to the microprocessor! The speaker is not connected. The system board's timer has failed. SCA34 SCA11 SCA08 SCA04 SCA12 SCA13 SCA05 SCA01 SCA01 SCA01 SCA05 SCA04 SCA32 SCA01 SCA23 SCA31 SCA01 Two different sized memory modules are in the same bank. A memory error occurred during your last session. SCA35 SCA37 Several memory errors occurred during your last session. SCA38 The system board's DMA controller has failed. SCA01 A memory module has failed. A memory module or the system board has failed. SCA36A SCA14 The system board's memory controller has failed. A memory module or the system board ROM has failed. Accessory board ROM(s) failed to be shadowed (copied) to RAM. Setup information specifies a SCSI accessory board which is not detected inside the computer. The parameters returned by the display do not match the DDC1 standard used by your PC for automatic set up of ergonomic refresh rates. The system board's interrupt controller has failed. SCA01 SCA25 SCA16 SCA16 SCA29 SCA01