HP Z24q Maintenance and Service Guide - Page 20
USB-B connector USB1, Lift the USB-B connector from the PCB.
![]() |
View all HP Z24q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3) Lift the DP connector from the PCB. 4) Place the new component on the PCB. Be sure that it matches the PCB footprint. 5) Solder the new component. USB-B connector USB1 Repair the USB-B connector: 1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin. 2) Lift the USB-B connector from the PCB. 3) Place the new component on the PCB. Be sure that it matches the PCB footprint. Solder the new component USB-A connector USB2/USB3 Repair the USB-A connector: 1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin. 17
![](/manual_guide/products/hewlettpackard-z24q-maintenance-service-guide-4d747c2/20.png)
17
3)
Lift the DP connector from the PCB.
4)
Place the new component on the PCB. Be sure that it matches the PCB footprint.
5)
Solder the new component.
USB-B connector USB1
Repair the USB-B connector:
1)
Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2)
Lift the USB-B connector from the PCB.
3)
Place the new component on the PCB. Be sure that it matches the PCB footprint.
Solder the new component
USB-A connector USB2/USB3
Repair the USB-A connector:
1)
Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.