HP st5747 Hardware Reference Guide HP st5742/st5747 Streaming Thin Clients - Page 24

Installing the USB Device, Removing and Replacing the Battery, WARNING

Get HP st5747 - Streaming Client PDF manuals and user guides View all HP st5747 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Installing the USB Device Before beginning the replacement process, review General Hardware Installation Sequence on page 11 for procedures you should follow before and after installing or replacing hardware. ▲ Insert the USB device into the USB port in the secure USB compartment. See the following illustration for the location of the ports in the secure USB compartment. Figure 2-7 USB ports in the secure USB compartment Removing and Replacing the Battery Before beginning the replacement process, review General Hardware Installation Sequence on page 11 for procedures you should follow before and after installing or replacing hardware. WARNING! You must remove the right side panel to access the battery. Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove and replace the battery: 1. Locate the battery on the system board. 18 Chapter 2 Hardware Changes ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
Installing the USB Device
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
11
for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-7
USB ports in the secure USB compartment
Removing and Replacing the Battery
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
11
for procedures you should follow before and after installing or replacing hardware.
WARNING!
You must remove the right side panel to access the battery. Before removing the side
access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
18
Chapter 2
Hardware Changes
ENWW