HP vc4825T HP vc4820T/vc4825T Thin Clients Hardware Reference Guide - Page 12

Installing the Stand, Removing the Stand

Get HP vc4825T - Thin Client PDF manuals and user guides View all HP vc4825T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

3. Align the feet with their holes and press them in securely. Figure 1-5 Installing the rubber feet Installing the Stand If you wish to use the thin client in a vertical orientation, you should install the stand for stability. To install the stand: 1. Turn unit upside down. 2. Locate the slots on the bottom of the unit into which the tabs on the stand fit. Position the stand with the wide part toward the front of the unit. Align the tabs on the widest part of the stand with the slots approximately 7.6 cm (3 inches) from the front of the unit and the tabs on the narrower part with the slots approximately 3.8 cm (1.5 inches) from the rear of the unit. 3. Insert the tabs into the slots and press the stand down until it locks into place. Figure 1-6 Installing the stand Removing the Stand To remove the stand: 1. Turn unit upside down. 6 Chapter 1 Product Features ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
3.
Align the feet with their holes and press them in securely.
Figure 1-5
Installing the rubber feet
Installing the Stand
If you wish to use the thin client in a vertical orientation, you should install the stand for stability.
To install the stand:
1.
Turn unit upside down.
2.
Locate the slots on the bottom of the unit into which the tabs on the stand fit. Position the stand
with the wide part toward the front of the unit. Align the tabs on the widest part of the stand with
the slots approximately 7.6 cm (3 inches) from the front of the unit and the tabs on the narrower
part with the slots approximately 3.8 cm (1.5 inches) from the rear of the unit.
3.
Insert the tabs into the slots and press the stand down until it locks into place.
Figure 1-6
Installing the stand
Removing the Stand
To remove the stand:
1.
Turn unit upside down.
6
Chapter 1
Product Features
ENWW