Hitachi 55DMX01W Owners Guide - Page 10

FRONT PANEL JACKS AND CONNECTIONS The front panel jacks are provided as a convenience to allow you to easily connect a VCR, PC or camcorder as shown in the following examples: ̇ ̇ ̇ S-VIDEO VIDEO AUDIO IN VIDEO 3/PC2 L/(MONO) R VIDEO 3 54321 10 9 8 7 6 15 14 13 12 11 PC2 INPUT MENU VOL- VOL+ CH- CH+ TV/PC EXIT SELECT ̇̈ S-VIDEO VIDEO AUDIO IN VIDEO 3/PC2 L/(MONO) R VIDEO 3 54321 10 9 8 7 6 15 14 13 12 11 PC2 INPUT MENU VOL- VOL+ CH- CH+ TV/PC EXIT SELECT ̇̈ A/V Cable and S-INPUT Cable (Optional) Audio Cable (Optional) D-SUB 15 Pin RGB Cable (Optional) S-VIDEO V L R OUTPUT Back of VCR PC ̇ ̇ ̇ S-VIDEO VIDEO AUDIO IN VIDEO 3/PC2 L/(MONO) R VIDEO 3 54321 10 9 8 7 6 15 14 13 12 11 PC2 INPUT MENU VOL- VOL+ CH- CH+ TV/PC EXIT SELECT ̇̈ S-VHS Video Camera Output AUDIO OUT Back of PC NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may be abnormal. If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable. If you have a mono VCR, insert the audio cable into the left audio jack of your TV. INPUT 3 audio can be used for PC INPUT 2 audio when a PC INPUT 2 is connected. NOTE: Optional adapter for *Apple® Macintosh® computers. If the optional AESP model G301/U Macintosh to VGA® adapter connector is configured and connected between Macintosh video out and the Rear Projection Television video in, the Macintosh is forced to boot in 640 x 480/60 Hz or 800 x 600/60 Hz mode (set mode) because the operational adapter correctly manipulates the Macintosh sense pins. For the optional adapter to work, it s DIP switch settings should be # 2, 3, 6, 7 = ON and # 1, 4, 5, 8, 9, 10 = OFF. See below: Example - See Switch Instructions for details. Mode 5 = 2367 (SVGA 800 x 600/60 Hz configuration) (VGA 640 x480/60 Hz configuration) Composite Separate Sync SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 ON ON ON ON OFF OFF OFF OFF SW9 OFF SW10 OFF ON 2 3 67 ON DIP 1 2 3 4 5 6 7 8 9 10 1 4 5 8 910 OFF 10