Hitachi C52-WD9000 Owners Guide - Page 26
Av Presetting
View all Hitachi C52-WD9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
ON-SCREEN DISPLAY MENUǏSETUP MENUǐ 10 If the picture is noisy due to weak RF signals from some channels, you can reduce noise by using TV NR function. Press the Ÿ ź cursor buttons to select the TV NR option and then press the Ż Ź cursor buttons to select Off, Low and High to turn off noise reduction function, activate low noise reduction and high noise reduction respectively. Different channels can be set independently. Note: This option is valid only for RF signal from antenna. 7XQLQJ 7XQLQJ0RGH 5 3URJUDP1XPEHU 6HDUFK 0+] 6NLS 2II 6RXQG6\VWHP $XWR &RORU6\VWHP $XWR 3URJUDP1DPH 7915 $OO3URJUDP 6HOHFW 6HW Ź 2II 5HWXUQ 11 All Program in Tuning menu can automatically search all available frequencies and store all stations available to the program numbers starting from the current 7XQLQJ 7XQLQJ0RGH 5 3URJUDP1XPEHU program No. Press the Ÿ ź cursor buttons to select the Program 6HDUFK 6NLS 0+] 2II Number option on the menu, press the Ż Ź cursor 6RXQG6\VWHP $XWR buttons or number buttons to select program No. &RORU6\VWHP $XWR Press the Ÿ ź cursor buttons to select the All Program 3URJUDP1DPH option as shown on the right. Then press the ENTER button to begin the auto tune procedure. The word Searching will appear at the bottom of the menu, and the 7915 $OO3URJUDP 6HOHFW 6HW 2II Ź 5HWXUQ TV will search for all frequencies and store all tuned frequencies to the program numbers starting from the Program Number selected. In the process of searching, press the ENTER button to quit. After complete the searching, the TV will quit the menu automatically. AV PRESETTING 3UHVHWź Press the TV/VIDEO button to switch the picture to the $90RGH 9 AV mode. &RORU6\VWHP$XWR Enter the Preset menu to display the menu as shown on the right. Press the Ÿ ź cursor buttons to select the AV Mode option and the Ż Ź cursor buttons or the TV/VIDEO button to select AV1, AV2, AV3, AV4 or AV5. 6HOHFW 6HW 5HWXUQ Press the Ÿ ź cursor buttons to select the Color System option, then press Ż Ź cursor buttons to select Auto, PAL, SECAM, NTSC4.43 or NTSC3.58. If the picture in AV mode is abnormal resulted from incorrect color system, you can use the Color System option to select the correct system. When receiving component signal (Y, PB/CB, PR/CR) from INPUT1 (or HDMI INPUT interface) or INPUT2 terminal, though the Color System option can be set, it has no effect on the picture. This is normal. (The C43-FL9000 model does not have HDMI INPUT interface.) 26