Hitachi PJ TX100 Owners Guide - Page 12

Power on/off Power on/off WARNING ►When the power is on, a strong light is emitted. Do not look into the lens or vents of the projector. NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices. Power switch STANDBY/ON POWER TEMP LAMP STANDBY/ON button POWER indicator POWER button POWER LIGHT OPT BLK MODE MEMORY ASPECT IRIS ENTER MENU RESET BRIGHT CONTRAST COLOR DVI PC AUTO COMPO S-VIDEO VIDEO Turning on the power 1. Make sure that the power cord is firmly and correctly connected to the projector and outlet. POWER 2. Remove the lens cover, and set the power switch to the ON position. (Solid orange) The power indicator will light to solid orange. Then wait POWER several seconds because buttons may not function for these several seconds. (Blinking green) 3. Press the button STANDBY/ON (projector) or POWER (remote control). POWER (Solid green) The projector lamp will light up and the POWER indicator will begin blinking green. When the power is completely on, the indicator will stop blinking light green. To display the picture, select an input signal according to the section "Selecting an input signal" ( 13). Then select the aspect ratio ( 13), adjust the picture position ( 7), and adjust the zoom and focus ( 14). Turning off the power 1. Press the button STANDBY/ON (projector) or POWER (remote control). The message "Power off?" will appear on the screen for approximately 5 seconds. Power off? 2. Press the button STANDBY/ON (projector) or POWER (remote control) again while the message is visible. The projector lamp will go off, and the POWER indicator will begin blinking orange. Then the POWER indicator will stop blinking and light to solid orange when the lamp cooling is complete. POWER (Blinking orange) POWER 3. Set the power switch to the OFF position. The POWER indicator will go off. 12 (Solid orange)