Hitachi PJ TX100 Owners Guide - Page 29

ENGLISH Multifunctional settings OPTION Menu With the OPTION menu, items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below. MENU [RGB] PICTURE IMAGE INPUT SETUP SCREEN OPTION EASY MENU AUTO OFF LAMP TIME FILTER TIME SERVICE :SELECT 0 0 0 Item AUTO OFF LAMP TIME FILTER TIME Description Set the time using the ▲/▼ buttons. : Long (max. 99 minutes) Short (min. 0 minute = DISABLE) AUTO OFF ENABLE AUTO OFF DISABLE ex. 1 0 When the time is set to 1 to 99, the projector lamp will go off and the power indicator begins blinking when the passed time with a proper signal (without no-signal and an unsuitable signal) reaches at the set time. Please refer to the section "Turning Off The Power". Pressing the RESET button for about 3 seconds displays the LAMP TIME menu. Select the RESET using ▲ button to reset the timer. : RESET CANCEL Selecting the RESET resets the count of the lamp timer to 0. memo Perform this function only when you have replaced the lamp. The lamp timer counts the used time of the current lamp, to display the messages about the lamp. Incorrect performing causes incorrect operation of the messages. memo About replacing the lamp, please refer to the section" Lamp". Pressing the RESET button for about 3 seconds displays the FILTER TIME menu. Select the RESET using ▲ button to reset the timer. : RESET CANCEL Selecting the RESET resets the count of the lamp timer to 0. memo Perform this function only when you have cleaned or replaced the air filter. The filter timer counts the used time of the air filter after cleaning or replacement, to display the messages about the air filter. Incorrect performing causes incorrect operation of the messages. memo About caring for the air filter, please refer to the section "Air Filter". 29