Hitachi SP18VAH Instruction Manual - Page 15
Maintenance And Inspection
UPC - 717709007680
View all Hitachi SP18VAH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English MAINTENANCE AND INSPECTION WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and inspection. 1. Inspecting the screws Regularly inspect all screws and ensure that they are properly tightened. Should any of the screws be loosened, retighten them immediately. WARNING: Using this electronic sander polisher with loosened screws is extremely dangerous. Wear limit 2. Inspecting the carbon brushes (Fig. 8) The motor employs carbon brushes which are consumable parts. Replace the carbon brush with a 43 new one when it becomes worn to its wear limit. Always keep carbon brushes clean and ensure that No. of carbon they slide freely within the brush holders. Fig. 8 CAUTION: q Using this electronic sander polisher with a carbon brush which is worn in excess of the wear limit will damage the motor. NOTE: Use HITACHI carbon brush No. indicated in Fig. 8. ⅜ Replacing carbon brushes: Remove the brush caps (Fig. 1) with a slotted screwdriver. The carbon brushes can then be easily removed. 3. Cleaning lock pin section If the lock pin section becomes dirty, clean it at once. 4. Service and repairs All quality power tools will eventually require servicing or replacement of parts because of wear from normal use. To assure that only authorized replacement parts will be used, all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE CENTER, ONLY. 15