Honeywell 2092D Operation Guide - Page 6

Testing the Passcode - fire safe

Get Honeywell 2092D - Waterproof Fire Safe PDF manuals and user guides
UPC - 016247020923
View all Honeywell 2092D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Test Locking System Testing the Passcode 1. With the safe door open and the Live Bolts engaged, you can now test the Electronic Locking System using the pre-set three digit factory code. Locate the digital keypad on the front of the safe and open up the protective cover to expose the keypad. 2. When the cover is opened, the keypad is activated and the keypad backlight will turn on and remain on for approximately 5 seconds. When the backlight turns off, the keypad is still active and the backlight will turn on again when any key is pressed. 3. The pre-set three digit factory Passcode is 159. Enter this Passcode as follows: Note: All entries are accompanied by a beep and the green light will flash. 4. After properly entering the entire sequence, the green light will turn on and the lock will "click". You now have 5 seconds to open the safe by turning the safe door handle upward to the right. Important: IF HANDLE WILL NOT TURN If the handle will not turn to the right after the green light comes on, first turn the handle slightly back to the left until it stops, then turn upwards to the right again to open. 5. Once the handle has been turned to the right, the Live Bolts will be disengaged and retract into the door. You have successfully unlocked the safe and the door is now in the unlocked position. 6. Leave the safe door open and proceed to Programming a Personal Passcode. Important: SECURITY LOCKOUT PERIODS For added security, the safe will automatically "Lockout" entry for 15 minutes after three attempts to open with an invalid Passcode. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
4
Test Locking System
Testing the Passcode
1.
With the safe door open and the Live Bolts engaged, you can
now test the Electronic Locking System using the pre-set three
digit factory code.
Locate the digital keypad on the front of the
safe and open up the protective cover to expose the keypad.
2.
When the cover is opened, the keypad is activated and the
keypad backlight will turn on and remain on for approximately 5
seconds.
When the backlight turns off, the keypad is still active
and the backlight will turn on again when any key is pressed.
3.
The pre-set three digit factory Passcode is 159.
Enter this
Passcode as follows:
Note:
All entries are accompanied by a beep and the green light
will flash.
4.
After properly entering the entire sequence, the green light will
turn on and the lock will “click”. You now have 5 seconds to
open the safe by turning the safe door handle upward to
the right.
Important: IF HANDLE WILL NOT TURN
If the handle will not turn to the right after the green light comes on, first turn
the handle slightly back to the left until it stops, then turn upwards to the right
again to open.
5.
Once the handle has been turned to the right, the Live Bolts will be
disengaged and retract into the door.
You have successfully unlocked the
safe and the door is now in the unlocked position.
6.
Leave the safe door open and proceed to Programming a Personal Passcode.
Important: SECURITY LOCKOUT PERIODS
For added security, the safe will automatically “Lockout” entry for 15 minutes
after three attempts to open with an invalid Passcode.