Honeywell 4800dr Barcode Guide - Page 24
Scan Stand Mode, Presentation Mode
View all Honeywell 4800dr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
or using a serial trigger command. After scanning the Read Time-Out barcode, set the time-out duration (from 0-300,000 milliseconds) by scanning digits from the inside back cover, then scanning Save. Default = 30,000. Read Time-Out Scan Stand Mode When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan Stand symbol. (See Scan Stand Symbol on page 3-4.) When a different code is presented, the document reader is triggered to read the new code. Note: The document reader automatically adjusts the illumination LEDs to the lowest light level possible to maintain a good lock on the Scan Stand symbol. When a symbol is presented, the document reader's light levels adjust to the saved setting (see LED Power Level on page 3-6). This mode requires at least 50 lux of ambient light to operate correctly. Scan Stand Mode Scan Stand Symbol When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand Symbol on the base of the stand which tells it to remain idle. When the Scan Stand symbol is covered, the document reader turns the LEDs on at the configured power level (Default High) and attempts to find and decode barcodes in its field of view. Scan Stand Symbol Presentation Mode This programs the document reader to work in Presentation mode. The LEDs are either off or at the lowest power for ambient conditions until a barcode is presented to the document reader. Then the LEDs turn on automatically to read the code. Presentation Mode uses ambient light to detect the barcodes. If the light level in the room is not high enough, Presentation Mode may not work properly. Presentation Mode 3 - 4