Honeywell MK1650-62B14 User Guide - Page 18
Stand Alone Keyboard IS1650-47
![]() |
View all Honeywell MK1650-62B14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
INSTALLATION CABLE INSTALLATION (INTERFACE SPECIFIC) Stand Alone Keyboard IS1650-47 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socket on the IS1650. There will be an audible click when the connector lock engages. 3. Plug the other end of the communication cable into the host's keyboard port. 4. Plug the external power supply (required) into the power jack on the PowerLink cable. Check the AC input requirements of the power supply to verify the voltage matches the AC outlet. The outlet must be located near the equipment and be easily accessible. 5. Connect the power supply transformer to an appropriate AC power outlet. Figure 10. 6. The IS1650 will start to initialize. All LEDs (yellow, white, and blue) will light for approximately 2 seconds then start to alternately flash. When the scanner has finished initializing the LEDs will stop flashing and the unit will beep three times indicating that the scanner is ready for use. 7. Turn on the host device. Plugging the scanner into a port on the host device does not guarantee that scanned information will be communicated properly to the host device. The scanner is shipped from the factory configured with default settings. Please refer to the MetroSelect Single-Line Configuration Guide (MLPN 00-02544) or MetroSet2's help files for instructions on changing the scanner's configuration. In addition, please check that the scanner and host system are using the same communication protocol. See SELV Power caution statement located on page 10 of this manual. 14
![](/manual_guide/products/honeywell-mk165062b14-user-guide-c79378d/18.png)