Honeywell PRO22IC Installation Manual - Page 10
LED Operation
View all Honeywell PRO22IC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Installation Guide PRO-2200 Intelligent Controller PRO22IC DIP Switch Settings: S8 S7 S6 S5 S4 S3 S2 S1 SELECTION OFF OFF OFF ON ADDRESS 1 OFF OFF ON OFF ADDRESS 2 OFF OFF ON ON ADDRESS 3 OFF ON OFF OFF ADDRESS 4 OFF ON OFF ON ADDRESS 5 OFF ON ON OFF ADDRESS 6 OFF ON ON ON ADDRESS 7 OFF OFF OFF OFF ADDRESS 8 OFF ON OFF OFF OFF ON ON OFF ON ON OFF ON LED Operation PORT 1: NO HARDWARE FLOW CONTROL PORT 1: HARDWARE FLOW CONTROL 115.2K BPS 9,600 BPS 19,200 BPS 38,400 BPS NO PASSWORD PASSWORD LOGON REQUIRED The controller uses three on-board LEDs to provide status information during its power-up sequence and normal operation. MODE Power-up Sequence Normal Operation LED LED LED A B C ON OFF OFF OFF ON ON OFF ON OFF ON ON ON FLASH FLASH FLASH DESCRIPTION Start Power-up, hardware setup Testing RAM and Clearing Database (approx. 5 sec./MB) Testing RAM and NOT Clearing Database (approx. 5 sec./MB) database is O.K. Power-up complete, held for 1 second This LED has a faint flicker and should flash once every second when system is active. Flash when there is activity on Host Port 1 Flash when there is activity on I/O Port. (Ports 2 & 3 )