Honeywell TH5110D1006 Installation Guide - Page 6
Installer setup - wiring
UPC - 085267256988
View all Honeywell TH5110D1006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Guide Installer setup Follow the procedure below to configure the thermostat to match the installed heating/cooling system, and customize feature operation as desired. Function number Setting 10 Done Next To begin, press and hold the s and FAN buttons until the display changes. M29387 Press s or t to change settings. Press NEXT to advance to the next function. Press DONE to exit and save settings. Setup function Settings & options (factory default in bold) Shaded areas below apply only to TH5320U/TH5220D or as otherwise noted. 1 System type 0 1 heat/1 cool conventional 1 1 heat/1 cool heat pump (no aux. heat) 2 Heat only - 2-wire systems, 3-wire zone valves (Series 20), and normally open zone valves 3 Heat only with fan 4 Cool only 5 2 heat/1 cool heat pump (with aux. heat) 6 2 heat/2 cool conventional 7 2 heat/1 cool conventional 8 1 heat/2 cool conventional 9 2 heat/2 cool heat pump (no aux. heat) - TH5320U only 10 3 heat/2 cool heat pump (with aux. heat) - TH5320U only 2 Changeover valve (O/B terminal) 0 Changeover valve (O/B terminal energized in cooling) 1 Changeover valve (O/B terminal energized in heating) 3 Fan control (heating) 0 Gas or oil furnace - equipment controls fan in heating 1 Electric furnace - thermostat controls fan in heating 5 Stage 1 heat cycle 5 rate (CPH: cycles/hour)* 1 3 9 For gas or oil furnaces of less than 90% efficiency For steam or gravity systems For hot water systems & furnaces of over 90% efficiency For electric furnaces 6 Stage 2 heat cycle rate/Auxiliary heat cycle rate (CPH)* 5 For gas or oil furnaces of less than 90% efficiency 1 For steam or gravity systems 3 For hot water systems & furnaces of over 90% efficiency 9 For electric furnaces 7 Auxiliary heat cycle 5 rate (CPH)* 1 3 Only TH5320U 9 for 3H/2C Heat Pumps For gas or oil furnaces of less than 90% efficiency For steam or gravity systems For hot water systems & furnaces of over 90% efficiency For electric furnaces 8 Emergency heat cycle 9 rate (CPH)* 1 3 5 For electric emergency heat For steam or gravity systems For hot water systems & furnaces of over 90% efficiency For gas or oil furnaces of less than 90% efficiency *[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH] 69-1922EFS-01 6 Continued on next page ENGLISH