Hoover 72-59139 User Guide - Page 13
Maintenance
View all Hoover 72-59139 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3-16 Cleaning upholstery 3-17 A B 9. Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke). It is best to alternate wet and dry strokes as described above. End with more dry strokes and watch for the green 'MAX Extract' light to come on to aid in faster drying of carpet. 10. Overlap strokes by 1/2 inch to help prevent streaking. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes. If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again. 11. Empty recovery tank when the red 'MAX Extract' light comes on and the motor sound becomes higher pitched and there is a loss in suction (see "Automatic shut-off", Fig. 2-7). When finished cleaning, follow "After cleaning" instructions on page 9 and "After using tool" instructions on page 12. Read "Before you begin cleaning" instructions on page 9. Be sure to check the cleaning code on your upholstery. Use your deep cleaner only on upholstery marked "W"or "W/S". 1. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. 2. Fill clean solution tank with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-9 to 2-15. 3. Attach tool to end of hose. Do not point tools toward people or pets. 4. Dry hands and plug deep cleaner into a properly grounded outlet. 5. Turn deep cleaner ON. If necessary, refer to "Before using tool" section to remove air from the system. 6. Gently press the tool onto the fabric. Press the trigger and slowly pull the nozzle over the fabric. 7. Overlap strokes by 1/2 inch to help prevent streaking. Make additional strokes without pressing the trigger to remove more moisture. Also, periodically checking the 'MAX Extract' lights will help ensure that the maximum amount of water has been removed. 8. To clean in corners or creases, lift the tool one-half inch from the fabric and press the solution trigger. The crevice tool is very useful for this task. 9. Vacuum up the solution with the tool without pressing the trigger. 10. For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass. 3-18 Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. 11. Empty recovery tank when the red 'MAX Extract' light comes on and the motor sound becomes higher pitched and there is a loss in suction (see "Automatic shut-off", Fig. 2-7). When finished cleaning, follow "After cleaning" instructions on page 9 and "After using tool" instructions on page 12. 4. Maintenance H e a d l i g h t re p l a c e m e n t What to buy The deep cleaner uses a 7 volt, wedge base type bulb, HOOVER part no. 2 7 3 1 3 1 0 6 . Where to buy Bulbs may be purchased from authorized Hoover dealers (Depot), Hoover Factory Service Centers, or through The Hoover Company online at www.hoover.com. 4-1 How to replace Turn cleaner off and with dry hands, disconnect deep cleaner from electrical outlet. 1. Using a Phillips screwdriver, remove the screw as shown and lift off lens. Continued § 13